DCC concepts

Cobalt mounting foam pads - 12 pack - DCC concepts
Twelve custom cut double sided foam mounting pads and specially prepared, “selectively glued,” colour-printed ballast labels for use under the tie-bar. (Usable with and highly recommended for all Cobalt variants.)

Cobalt Tiebar labels - 12 pack - DCC concepts
Een set met 12 stuks ballast labels voor alle typen Cobalt wisselmotoren.
Met de labels kunt u het gaatje onder de wisselstang verbergen.

The Cobalt Relay extension board is a versatile relay switching interface that allows you to do almost any form of interlocking automated switching or automation.
Use via manual switches or control it with detectors etc.. Rex can be used for DC and DCC layouts.
Rex has 4 relays on board which can be used all four together or in pairs.
Power input: 12 to 18 volts DC or DCC.
 

These detectors have been designed to be very easy to install. With only a diameter of 4mm, they will fit between the sleepers of Peco Code 100 and Code 75 track.

The detectors are 'Normally Off' and are triggered by a small magnet that is attached to the loco or rolling stock.

Ideal to operate point motors or level crossings
 

A pack of 10 assorted brass point rodding cranks plus fixing pins etc.


Manual

More DCCconcepts products

A pack of three compensating medium high (6.25mm post) brass point rodding cranks plus fixing pins etc.


 

A pack of six TALL (9.25mm post) brass point rodding cranks plus fixing pins etc.

 

A pack of six Medium high (6.25mm post) brass point rodding cranks plus fixing pins etc.

 

100 hardened and gold plated pins for fixing of rod stools, track or many other things around the layout.

Small and subtle but very strong, the gold plating also makes then easy to solder to.

Caution – they are hard, so only use a file or hardened cutters to trim to length.

 

Rodding stools are surprisingly close together on the prototype so you will need lots for longer runs.

This pack contains 100 ready-to-use cranks

 

The Rod only pack contains 40 250mm lengths of rodding, rod pockets and mounting rivets plus some turnout motor linkages.