Model 2 servo support for up to three mini servos

€4.50
3 on stock
sku
EMS-MiniModel2
Model 2 servo support for up to three mini servos
This model can hold up to three mini servos. This gives one the opportunity to operate a three arm semaphore signal. Also one can operate one point and a semaphore signal from this support. In the latter case the space for the second servo is left open.
M2 bolts and nuts are delivered together with the support to mount a mini servo.
A mini servo is not included.

How to operate a point
To operate a point with a servo the servo arm needs to be mounted vertically. With a wire thread through the turning point of the servo support one can operate a point.

Operating a semaphore signal or something else
To operate a semaphore signal the servo arm needs to be mounted horizontally. The operating wires of a signal can bent in a 90 degrees angle and mounted to a servo arm. When using the Model 2 servo support it is important to check if the servos would not foul each other when moving the arms. Also keep in mind that the arm movement is restricted to approximately 8mm. Most of the times this will be enough for a semaphore signal but might be insufficient for moving something else. In that case Model 2 is only suitable for two mini servos.

Servo support for mini servos for model railways
With servos one can operate arm signals, points and barrier gates. The servo supports are designed for use with mini servo’s (not included). The needed space below a model railway is small as both servo support and mini servo are small.

The servo support is available in two types.
The basic model and Model 2 for up to three mini servos

Dimensions
Model 2 without servos (lxwxh): 45 x 25 x 45 mm

Maximum dimensions mini servo
23 x 12 mm (lxh)
More Information
Price €4.50
material plastic
Write Your Own Review
You're reviewing:Model 2 servo support for up to three mini servos
Your Rating